Ion Deodorization Equipment

Post a Purchase Request

Reverse osmosis equipment uses membrane separation technology to effectively remove charged ions, inorganic matter, colloidal particles, bacteria and organic substances from water.

Design Features

1. Deep filtration is achieved by increasing water pressure. In addition to ordinary filters, RO pure water equipment includes precision filters, granular activated carbon filters and compressed activated carbon filters. Precision filters filter more finely than ordinary filters and remove impurities from water more effectively. As is well known, activated carbon adsorbs odors and impurities well; RO pure water equipment uses dual activated carbon filters to deeply treat the raw water, improving filtration efficiency. Increasing water pressure to enhance filtration capacity is also an innovation.

 

2. The core of RO pure water equipment is the reverse osmosis membrane. An RO membrane is a filtration membrane with extremely small pores that enables ultra-fine filtration of raw water while separating it into higher-concentration and low-concentration streams. The higher-concentration water can be recycled, and the low-concentration water is pure water for human use.

 

 

Treatment System

The reverse osmosis system is the core component of the whole pure water system; only through reverse osmosis can water reach pure water standards. The RO system mainly uses a membrane filtration process: water molecules pass through the RO membrane, while ions such as calcium, magnesium and sodium are discharged with the wastewater. The system's components are described below.

 

1. Precision filter

 

Mainly filters out large particles in the water.

 

2. Special high-pressure pump

 

Provides strong power for the reverse osmosis equipment.

 

3. Reverse osmosis membrane

 

The RO membrane uses membrane filtration technology, letting water molecules pass while blocking other ions, thereby purifying the water.

 

The source water is a very important basis for pure water production, so pure water should be produced where the raw water quality is relatively good, such as mountain springs or deep wells. A very important indicator here is"conductivity". Generally, the lower the conductivity, the purer the water. The water treatment process used is a reverse osmosis system, and the treated water typically achieves a salt rejection rate of 90%-99%. The system's components are described below.

 

1. Raw water pump

 

The raw water pump supplies raw water pressure for the pretreatment system. If the raw water is already pressurized, this unit is not needed. Raw water pressure is generally required to be ≥ 0.3 MPa.

 

2. Raw water tank

 

The raw water tank simply stores raw water, serving as a buffer in case the raw water supply is interrupted.

 

3. Quartz sand filter

 

This unit mainly filters out microorganisms and dust to make the raw water clear.

 

4. Activated carbon filter

 

This unit mainly removes residual chlorine from the water.

 

5. Dosing system (cation exchange system)

 

Small systems mostly use a cation exchange system, while large systems mostly use a dosing system that adds antiscalant directly.

 

 

Process Flow

Source water tank→ Source water booster pump → Multimedia filter → Activated carbon filter → Cation resin softener → Precision filter → Stage 1 RO pure water system → Stage 2 RO pure water system → Water-gas mixer → Ozone sterilizer → Stainless steel pure water tank → Fully automatic filling line

 

Energy-saving and pollution-free

Post a Purchase Request

Items marked with "*" are required

Contact Us

Address: Liujin Road, Sitaizi Industrial Park, Bayuquan District, Yingkou, Liaoning, China

Contact: Mr. Li Chuanyi +86 138 4076 5457

Technical Service: Mr. Song (Engineer) +86 183 0417 8511

Factory Tel: 0417-2267160

E-Mail: 113329659@qq.com
xygs66888@163.com

Xiyuan