How to Install and Maintain Grinder Bar Screens
The grinder bar screen is equipment for handling solid waste. It effectively grinds large solids into small particles that flow with the sewage into the pipes without causing blockages. Grinder screens are generally fully buried together with the pump station; they are small, light and low in civil construction cost. There is no need to haul away or fish out debris, and no secondary pollution.
To install a grinder screen, first bolt the grinder screen rails in place, then mount the side plates on both sides of the main unit and fix them with bolts. After installation, insert the unit into the channel along the installed rails. Take care to keep the upper and lower rollers aligned when inserting the unit into the rails to avoid damaging them. Once the main unit is installed, insert the overflow screen into the channel along the rails so that it sits above the unit.
Before maintaining a grinder screen, always make sure it is disconnected from the power supply and cannot be started accidentally, and that the screen and its parts are stable and will not roll or fall, to avoid injury or damage. Regular inspection and maintenance make grinder screen operation more reliable. During maintenance checks, note that severely worn cutters cause the leading edge to become unbalanced, and the motor may be overloaded by blockages. Next, check the seals for oil leaks and the motor for liquid leaks. Finally, check the cables, starting devices and monitoring devices for faults, and repair any faults immediately.
Common grinder screen faults are as follows:
1. Noise or vibration during operation.
This is usually caused by the grinder screen not being securely fixed or nuts being loose, unstable inflow conditions, or debris blocking the screen. The solution is to reinforce the foundation, check and adjust inflow conditions and remove debris.
2. The screen will not start, or the fuse blows.
This is usually caused by an open circuit in the windings, connections or cable, a blocked screen, or water or electrical leakage. Check the circuit and remove debris.
3. The circuit breaker trips after the screen starts.
This is generally caused by excessively high or low voltage, mixed-up motor wire connections or a faulty control cabinet. The solution is to install a transformer to adjust the voltage, correct the wiring connections, use thicker power cables, and inspect and replace electrical components.
Back


