How Should Chemical Tank Manufacturers Carry Out Maintenance?
1. For tanks storing flammable gases or liquids, necessary fire-fighting equipment must be provided; smoking, open-flame lighting or heating, and bringing any ignition source into the tank area are strictly prohibited.
2. For tanks storing flammable, explosive, toxic, corrosive or similar media, the relevant rules for managing hazardous materials must be strictly followed.
3. Before inspecting or repairing a tank, the power to all related electrical equipment must be cut off and equipment handover procedures completed.
4. After the tank has been fully drained, close the inlet and outlet valves or fit blind plates to isolate connected pipes and equipment, and post clear isolation signs.
5. Tanks that held flammable, corrosive, toxic or asphyxiating media must be purged, neutralized, disinfected and cleaned, and then sampled and analyzed; the results must meet the relevant standards and regulations. Tanks that held flammable media must never be purged with air.
6. Lighting inside the tank must use explosion-proof lamps rated at no more than 24 V.
7. Any hot work inside the tank requires a hot work permit.
8. A standby attendant must be assigned for work inside the tank, with reliable means of communication.
9. On completion, maintenance staff and the attendant jointly inspect inside and outside the tank; only after confirmation and the attendant's signature on the confined-space work permit may the manholes be closed.
10. When draining water after a pressure test, the tank must be vented to the atmosphere to prevent a vacuum. As a general note, oil tanks and tank farms store large quantities of oil and carry high risk, with fires and explosions liable to occur. Fire and explosion prevention rules must be established in accordance with the relevant regulations, fire patrols carried out regularly and fire safety management strictly enforced to ensure fire safety.
Back


