GRP Pump Station Shaft Fabrication Is Gaining More and More Attention!

GRP Pump Station Shaft Fabrication

  1. Hand lay-up: mainly used in Norway, Japan, the UK, Denmark, etc.

  2. Spray-up: Sweden, the US, Norway, etc. are the main countries using it.

  3. Molding: mainly used in Germany and other countries.

  4. RTM (resin transfer molding): mainly used in Europe, the US and Japan.

  Others include filament winding, pultrusion and hot-press casting.

  Over 90% of China's GRP products are made by hand lay-up; others are made by molding, winding, lamination, etc. Hand lay-up still accounts for 50% in Japan. Worldwide, hand lay-up still accounts for a considerable share, showing it remains viable. It uses wet resin for forming, with simple equipment and low cost, and products over 10 m can be laid up in one go. Its drawbacks are a low degree of mechanization, long production cycles and unstable quality. China has imported extrusion, spraying, winding and other process equipment from abroad, and as the GRP industry develops, new processing methods will keep emerging.

GRP pump stations offer advantages traditional pump stations lack, such as fast construction, strong adaptability, long service life and environmental friendliness. They are an ideal replacement for traditional stations and can be used to discharge domestic sewage, stormwater and industrial wastewater, or to draw water from a source. They are a new generation of green technology products.

Back

Product Categories

Contact Us

Address: Liujin Road, Sitaizi Industrial Park, Bayuquan District, Yingkou, Liaoning, China

Contact: Mr. Li Chuanyi +86 138 4076 5457

Technical Service: Mr. Song (Engineer) +86 183 0417 8511

Factory Tel: 0417-2267160

E-Mail: 113329659@qq.com
xygs66888@163.com

Xiyuan