What Is the Electrical System of a Grinder Bar Screen Like?
The grinder bar screen cleaner is sewage treatment equipment that continuously and automatically intercepts and removes debris of all shapes from fluids. It can be widely used in urban sewage treatment, the water supply industry and power plant water intakes, and also as primary screening equipment in wastewater treatment processes in the textile, food processing, paper and leather industries. It is a type of solid-liquid screening equipment.
Electrical system of the grinder bar screen cleaner:
① The electrical control cabinet is an outdoor rainproof cabinet with a double-door structure and viewing window, protection class IP55 or higher, and a stainless steel enclosure. Its shape and door locks are supplied to a specified design. Each outdoor cabinet has two doors: the outer door is a sealed glass viewing door, and the inner door carries start and stop buttons, energy-saving run, stop and fault indicator lights, a local-off-remote selector switch and an emergency stop button. The control box contains a motor protector, starter and auxiliary relays, PLC control input interfaces, output interfaces sending run, auto and fault status signals to the PLC, cable entries and terminal blocks.
② The electrical control cabinet provides manual, automatic, manual/auto switching, emergency stop, isolation, alarm and remote control functions. It also provides short-circuit protection, thermal overload protection, phase-loss protection, overcurrent protection, emergency stop protection and earth protection, with automatic protective shutdown in the event of a fault. Control: Manual — local control via the buttons on the control box. Automatic — the separator's operating cycle is controlled automatically by adjusting the timing. Remote — automatic control from the central control room via the PLC interface.
③ The main electrical components in the control box are imported.
④ The control cabinet provides volt-free contacts to send operating status, manual/auto mode and fault alarm signals to the central control room, and has a dedicated automatic control interface for the equipment that can receive remote control signals for remote operation. When the solid-liquid separator suffers an overload or other fault, it sends an alarm signal to the control center and stops.
Back


